Home/Products/Encoder Signal Processing/EasyLink
ENCODER DIVIDER · MULTIPLIER
EasyLink
Encoder Multiplier · Divider Coming soon
Divides or multiplies an encoder signal at a different ratio per channel and distributes it to multiple devices.
This product is coming soon. Specifications are development targets and may change.

THE PROBLEM
Low-resolution encoders (e.g. 10 PPR) can’t resolve position finely, while fast encoder signals may be too fast for a PLC.
HOW SYNEX SOLVES IT
Sets a multiply/divide ratio per channel and delivers the right pulse rate to each device.
Key features
Per-channel divide · multiply
Reduce (divide) or increase (multiply) pulses at any ratio on each output.
No cumulative error
Total output count always matches the set ratio exactly. Multiplication is based on constant-speed sections.
Per-channel direction invert
Swap A/B direction per output to match each device’s coordinate system.
Multi-channel output
One input to 4 / 8 independent output circuits — clean signals with no cross-talk.
Break / short detection
LED and error contact on encoder break or short. Monitors phase error and over-speed.
Configuration software
Set and check per-channel ratios and status over USB / RS-485.

Software
Software
Configurator — per-channel divide/multiply settings (example)
How it works
Per-channel divide · multiply
Multiplication is based on constant-speed sections · total output count always matches the set ratio (no cumulative error)
Specifications
| Input | A/B/Z differential (RS422), up to 40 MHz (×4) |
|---|---|
| Output | 4 / 8 CH, RS422 differential A/B/Z |
| Divide / multiply | Per-channel ratio, direction invert |
| Monitoring | Break/short, phase error, over-speed, error contact |
| Interface | USB, RS-485 (Modbus RTU) |
| Power | 5 VDC |
| Connector | D-SUB 9-pin (1 input + 4 / 8 outputs) |
※ Specifications are subject to change without notice. Contact us for detailed specifications.
Applications
Industry
Inspection · Measurement equipmentUse cases
- One encoder shared by motion controller, trigger and PLC
- Multiply to tune line-scan pitch, divide to match PLC input speed
Let’s check if it fits your machine
Tell us your machine setup and signal specs — we’ll start by reviewing whether it applies.


